Falcon 1000 DF User's Manual & Installation And Servicing Instructions

11Englishdifferent cleaning products - they may react togetherwith hazardous results.All parts of the cooker can be cleaned with hot soapywater - but take care that no surplus water seeps intothe appliance.Stainless Steel HobLift away pots or pans from hob. Remove pan supportsfrom spillage area and carefully place in a sink of warmsoapy water. Wipe loose debris from hob.Avoid using any abrasive cleaners including creamcleaners on brushed Stainless Steel surfaces. For bestresults use a liquid detergent cleaner.Rinse with cold water and thoroughly dry with a clean,soft cloth. Ensure all parts are dry before repositioning.Hotplate burnersThe burner heads and caps can be removed forcleaning. Make sure they are absolutely dry beforereplacing.Burner headBurner BezelWhen fi tting burner head, ensure this locates properlywithin the bezel.base of hotplate burner bottom of burner headIf you look at the bottom of the burner head you will seetwo ‘pips’; these fi t into the two notches in the burnerbase.Check burner ports are not blocked. If blockage occurs,remove stubborn particles using a piece of fuse wire.The Slow Cooking Oven and the GrillThe slow cooking oven and the grill have side panelsthat are coated with a special enamel that partly cleansitself.Do not use any cleaning material which may clog thepores of the special coating e.g. Pastes and powders,soap fi lled pads wire wool, spray cleaners, brush-onoven cleaners, caustic solutions, metal scrapers/knives,and prevent the continuous cleaning action.The shelf is designed to lock in place, but is removablefor cleaning. To remove lift up at the front then pullforward.The grill pan and grid should be washed in hot soapywater.After grilling meats or any foods that soil, leave to soakfor a few minutes in the sink immediately after use.Stubborn particles may be removed from the grid byusing a nylon brush.Control Panel and Oven DoorsFor best results liquid detergents should be used.The control panel and control knobs should only becleaned with a soft cloth wrung out in clean hot soapywater - but take care that no surplus water seeps intothe appliance. Wipe with a clean dampened cloth thenpolish with a dry cloth. The oven doors should only becleaned with a soft cloth wrung out in clean hot soapywater.Cleaning Brass ComponentsUncoated natural brass is used as part of the authenticunit fi nish on some models and may tarnish with age.To regain a polished fi nish, these areas should becleaned using a proprietary metal polish. Stubbornmarks on the aluminium burner rings can be removed