CHAPTER 3: INSTALLATION SET UP CYBERSENTRY AND CHANGE DEFAULT PASSWORDC70 CAPACITOR BANK PROTECTION AND CONTROL SYSTEM – INSTRUCTION MANUAL 3-593Figure 3-57: Quick Connect window to access a device5. Select the serial Interface and the communications port (COM Port) from the drop-down lists, then click Connect. TheCOM Port is that of the computer.6. The EnerVista software creates a site named “Quick Connect” with a corresponding device also named “QuickConnect” and displays them in the Online Window. Expand the sections to view data directly from the UR device. Usethe Device Setup button to change the site name.Each time that the EnerVista UR Setup software is initialized, click the Quick Connect button to establish directcommunications to the C70. This ensures that configuration of the EnerVista UR Setup software matches the C70 modelnumber.3.8.3 Use Quick Connect via a rear Ethernet portTo connect to a UR using an Ethernet cable:1. In the EnerVista software, click the Quick Connect button. The window opens.2. Select the Ethernet interface and enter the IP address assigned to the C70, then click the Connect button. TheEnerVista UR Setup software creates a site named “Quick Connect” with a corresponding device also named "QuickConnect" and displays them in the Online Window.3. Expand the sections to view data directly from the C70 device. Use the Device Setup button to change the site name.Each time that the EnerVista software is initialized, click the Quick Connect button to establish direct communications tothe C70. This ensures that configuration of the EnerVista UR Setup software matches the C70 model number.3.9 Set up CyberSentry and change default passwordIf and when first using CyberSentry security, use the following procedure for set up.1. Log in to the relay as Administrator by using the VALUE keys on the front panel or through EnerVista connected serially(so that no IP address is required). If logging in through EnerVista choose Device authentication. Enter the default
