5-24 C70 CAPACITOR BANK PROTECTION AND CONTROL SYSTEM – INSTRUCTION MANUALPRODUCT SETUP CHAPTER 5: SETTINGS5Pushbuttons (both user-control buttons and user-programmable buttons) located on the front panel can be pressed by anAdministrator or Engineer role. This also applies to the RESET button, which resets targets, where targets are errorsdisplayed on the front panel or the Targets panel of the EnerVista software. The RESET button has special behavior in that itallows these two roles to press it even when they are logged in through the RS232 port and not through the front panel.To reset the security event log and self-test operands:1. Log in as Supervisor (if the role is enabled) or Administrator (if the Supervisor role is disabled) and execute a clearsecurity command under Commands > Security > Clear Security.Security eventsThe security events produced when the CyberSentry option is purchased are sent as sytem log (syslog) messages to asyslog server, if one is configured. The format is as follows.Event Number — Event identification number (index)Date & Timestamp — UTC date and timeUsername — 255 chars maximum, but in the security log it is truncated to 20 charactersIP address — Device IP addressRole — 16 bit unsigned, of type format F617Activity Value — 16 bit unsignedSecurity log Event Number Date &TimestampUsername IP address Role Activity ValueEnumeration Role0 None1 Administrator2 Supervisor3 Engineer4 Operator5 FactoryEnumeration Description1 Authentication Failed2 User Lockout3 FW Upgrade4 FW Lock5 Settings Lock6 Settings Change. Because this can fill the entire event log, it is supported by thealready existing Settings_Change.log file. This event is not required.7 Clear Oscillography command8 Clear Data Logger command (not applicable to all UR products)9 Clear Demand Records command (not applicable to all UR products)10 Clear Energy command (not applicable to all UR products)11 Clear Unauthorized Access command12 Clear Teleprotection Counters command (not applicable to all UR products)13 Clear All Relay Records command14 Role Log in15 Role Log off
