CHAPTER 4: INTERFACES FLEXLOGIC DESIGN AND MONITORING USING ENGINEERC70 CAPACITOR BANK PROTECTION AND CONTROL SYSTEM – INSTRUCTION MANUAL 4-5144.4.7 ToolbarsThese are toggled in the View > Toolbar menu.The UR symbols are displayed for the toolbox icons. They change when the default setting is changed to IEC or ISOsymbols. The symbols displayed in the toolbox also vary by firmware version, reflecting what is supported for each release.4.4.7.1 FlexLogic Editor toolbar4.4.7.2 Token ToolboxDrawing ToolsNew Device Create a new settings fileOpen File Open an existing settings file in the URS, CID, or IID formatSave FlexLogic Save the Logic Designer diagramPDF Report Create a PDF document from Logic Designer diagram(s). Settings can bechanged under File > Preferences > Workbook Setup.Toggle Compile Window Display or hide the compile window areaSort Order Select to change the sort order of the Virtual Output list to the right of theicon. Virtual Outputs can be sorted numerically in ascending anddescending order based on numbers and names.Select VO to View (x - x) Select a Virtual Output to locate and select it in the workbook. Each VirtualOutput listed also contains the name of the sheet where the Virtual Outputis located.Edit ModeLogic DesignerSwitch to Logic Designer modeMonitor ModeLogic MonitorSwitch to Logic Monitor modeTurn On ALL Communications Turn on all communications to all Logic Designer diagrams that are in themonitoring mode. Default upon each launch of Engineer.Turn Off All Communications Turn off all communications to all Logic Designer diagrams that are in themonitoring mode. This is a legacy function for serial communication to turnoff communication to devices. Turning off communication applies to thecurrent session only. When you re-launch the EnerVista software,communication is on by default.Draw a line. Click and drag to draw.Draw multiple joined lines. Click and drag for each line. Double-click to finish.
