4-28 F60 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUALFRONT PANEL INTERFACE CHAPTER 4: INTERFACES4does not exist in the target relay or has not been enabled, then the component is displayed in the graphical front panel andin the drawing edit window in grey. The color scheme selection has no effect when an IEC style symbol is used because IECstyle symbols do not use color.Symbol orientationThe figure shows the orientation available for the breaker and disconnect switch (taking Open status as examples). Thedefault position is 0 degrees.Figure 4-33: Single-line diagram symbol orientationA question mark displays in a symbol on the graphical front panel when status is bad. The question mark does not rotatewith orientation.Figure 4-34: Symbols when status is badThe following figures show the orientation available for the static components. The default position is 0 degrees.
