CHAPTER 7: COMMANDS AND TARGETS TARGETS MENUF60 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL 7-137• Latched target message: No.• Description of problem: A faulty small form-factor pluggable port (SFP) or unplugging of the SFP generates this self testmessage.• What to do: The web page "SFP Transceiver Information" described in the previous section applies for this self test aswell. The "SFP Module Fail" has higher priority and it suppresses the "Ethernet Fail" target message. The "SFP MODULEFAIL FUNCTION" setting enables/disables this self test. The target for this self test is priority-based, with the third onebeing the highest priority. For example, if all three SFP modules fail, then the third SFP target is activated. If the thirdSFP module failure resolves, then the second SFP target is activated.• Latched target message: No.• Description of problem: The number of failures threshold was exceeded.• What to do: Wait for the lockout interval and try to authenticate again.• Message: "Unauthorized firmware attempt"• Latched target message: No.• Description of problem: A firmware upgrade operation was attempted while the lock relay setting was enabled.• What to do: Ask the Supervisor to unlock the relay and try again.• Message: "Unauthorized setting write"• Latched target message: No.• Description of problem: A setting write was attempted while the lock relay setting was enabled.• What to do: Ask the Supervisor to unlock the settings and try again.• Message: "An attempt to contact the Radius server has failed"• Latched target message: No.• Description of problem: The RADIUS authentication server is unavailable.• What to do: Verify network connectivity and try again.• Description of problem: There is a problem with the Compact Flash memory in the CPU module.• How often the test is performed: On relay power-up and afterwards once every 24 hours.• What to do: Contact the factory.• Description of problem: Seen until the builds is tagged as being 'release candidate' or 'gold' builds.SFP MODULE x FAILAUTHENTICATION FAILFIRMWARE LOCKSETTING LOCKSERVER UNAVAILABLEDOS PARTITION ALARM:SELF-TEST ERRORPROTOTYPE FIRMWARE:Self Test Error
