4-78 F60 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUALFLEXLOGIC DESIGN USING ENGINEER CHAPTER 4: INTERFACES44.4.5 Generate connectivity reportThis report displays basic information about a device, such as order code, port numbers, inputs and outputs. You can use itto create a PDF file of basic information. The report is based on CID and/or IID files, and not the system or full SCD. Alldevice details including Remote Inputs, Remote Outputs, and Analog Inputs/Outputs are indicated, including quantitiesused and available.To display a device report:1. In the Offline Window area of the software, expand the Engineer entry for the device.2. Double-click the Device Connectivity Report entry. The report displays.3. To save as a PDF file, click File > Save As.Figure 4-88: Device Connectivity Report4.4.6 PreferencesPreferences determine functionality. As such, you are encouraged to review them. This section outlines some optionsavailable in the menus and preference panels.Access them in the Logic Designer panel under the View menu and under File > Preferences. The Logic Designer andLogic Monitor preferences are outlined here, not all preferences for a device.4.4.6.1 View menuView > Toolbar > Advanced Actions — Active when in Logic Designer. Toggles a toolbar to nudge, rotate, flip, or changethe order of an element.View > Show Unused Pins — Enable to display unconnected pins. Disable to eliminate unconnected pins from the view, forexample when printing.
