GE PCS968 Owner's Manual

Also see for JCSP42: Owner's manual Owner's manual

Problem Possible Causes What To DoRange Locked or LOC The controls have • See the Control Lockout section to unlock.On appears in the oven been locked.display or LC appearsin the surface displayControl signals after You forgot to enter a • Touch the BAKE pad and desired temperature orentering cooking time bake temperature or the SELF CLEAN pad and desired clean time.or start time cleaning time.Display goes blank A fuse in your home may be • Replace the fuse or reset the circuit breaker.blown or the circuitbreaker tripped.The clock is in the • See the Special features of your oven control section.black-out mode.Display flashes Power failure. • Reset the clock.Unable to get the Oven control pads were • The BROIL HI/LO and BAKE pads must be touched atdisplay to show “SF” not touched properly. the same time and held for 3 seconds.“Probe” appears in This is reminding you to • Enter a probe temperature.the display enter a probe temperature(on some models) after plugging in the probe.Power outage, Power outage or surge. • Reset the clock. If the oven was in use, you must resetclock flashes it by touching the CLEAR/OFF pad, setting the clockand resetting any cooking function.Steam from the vent When using the ovens, • This is normal.it is normal to see steamcoming out of the ovenvents. As the number of racksor amount of food beingcooked increases, the amountof visible steam will increase.“Burning” or “oily” This is normal in a new oven • To speed the process, set a self-clean cycle for aodor emitting from and will disappear in time. minimum of 3 hours. See the Using the self-cleaningthe vent upper and lower ovens section.Strong odor An odor from the insulation • This is temporary.around the inside of the ovenis normal for the first few timesthe oven is used.Fan noise A convection fan may • This is normal. To maximize cooking evenness,automatically turn on the fan is designed to operate in both directions,and off. with a pause in between.• The convection fan will operate during preheatof the bake cycle. The fan will turn off after the ovenis heated to the set temperature. This is normal.42Consumer Support Care and Cleaning OperatingInstructions Safety InstructionsTroubleshooting tips