GE PGS975 Owner's Manual

Also see for Profile PGS908: Installation instructions Brochure Technical service guide Use and care manual Owner's manual

To Set the ClockThe clock must be set to the correct timeof day for the automatic oven timingfunctions to work properly. The time ofday cannot be changed during a timedbaking or self-cleaning cycle.Touch the CLOCK pad.Touch the number pads.Touch the START pad.Make sure the clock is set to thecorrect time of day.To Set the TimerTouch the KITCHEN TIMER pad.Touch the number pads until theamount of time you want showsin the display. For example, to set2 hours and 45 minutes, touch 2, 4and 5 in that order. If you make amistake touch the KITCHEN TIMERpad and begin again.Touch the START pad.After touching the START pad, SET disappears;this tells you the time is counting down, althoughthe display does not change until one minute haspassed. Seconds will not be shown in the displayuntil the last minute is counting down.When the timer reaches :00, thecontrol will beep 3 times followedby one beep every 6 seconds untilthe KITCHEN TIMER pad is touched.The 6-second tone can be canceled by followingthe steps in the Special features of your ovencontrol section under Tones at the End of aTimed Cycle.The timer is a minute timer only.The timer does not control ovenoperations. The maximum setting onthe timer is 9 hours and 59 minutes.To Reset the TimerIf the display is still showing the timeremaining, you may change it bytouching the KITCHEN TIMER pad, thentouch the number pads until the timeyou want appears in the display.If the remaining time is not in the display(clock, delay start or cooking time are inthe display), recall the remaining time bytouching the KITCHEN TIMER pad andthen touching the number pads to enterthe new time you want.To Cancel the TimerTouch the KITCHEN TIMER pad twice.Using the clock and timer.16Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions