Safety Instructions Operating InstructionsSafety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer SupportProblem Possible Causes What To Do“F—” and a number You have a function error code. • Touch the CLEAR/OFF pad. Put the oven back intoor letter flash operation.in the display If the function code repeats. • Disconnect all power to the range for at least 30seconds and then reconnect power. If the functionerror code repeats, call for service.Control signals after You forgot to enter a • Touch the BAKE pad and desired temperature orentering cooking time bake temperature or the SELF CLEAN pad and desired clean time.or start time cleaning time.Display goes blank A fuse in your home may • Replace the fuse or reset the circuit breaker.be blown or the circuitbreaker tripped.The clock is in the • See the Special features of your oven control section.black-out mode.Display flashes Power failure. • Reset the clock.Unable to get the Oven control pads were • The BROIL and BAKE pads must be touched atdisplay to show “SF” not touched properly. the same time and held for 3 seconds.“Probe” appears in This is reminding you to • Enter a probe temperature.the display enter a probe temperatureafter plugging in the probe.Power outage, Power outage or surge. • Reset the clock. If the oven was in use, you must resetclock flashes it by touching the CLEAR/OFF pad, setting the clockand resetting any cooking function.Steam from the vent When using the convection • This is normal.feature, it is normal to seesteam coming out of the ovenvent. As the number of racksor amount of food beingcooked increases, the amountof visible steam will increase.“Burning” or “oily” This is normal in a new oven • To speed the process, set a self-clean cycle for aodor emitting from and will disappear in time. minimum of 3 hours. See the Using the self-cleaningthe vent oven section.Strong odor An odor from the insulation • This is temporary.around the inside of the ovenis normal for the first few timesthe oven is used.Fan noise A cooling fan or a convection • This is normal. The cooling fan will turn off andfan (depending on the on to cool internal parts. It may run after the oven isfunction you are using) may turned OFF. The convection fan will cycle on and offautomatically turn on and off. until the function is over or the door is opened.LOC shows in the The Range Lock-Out feature • Be sure the surface burner controls are turned OFF.display is activated. Turn this feature off to use the range. See theRange Lock-Out section.GEAppliances.com41