Chapter 2. InstallationTransPort ® PT900 User’s Manual 352.6.2 Connecting the TransducersTo connect the transducers, see Figure 45 below and proceed as follows:1. Connect the cables from each of the transducers to the transmitter:a. Connect the transducer cable with the UP label on the cable connectorto the transmitter connector labeled UP.b. Connect the transducer cable with the DN label on the cable connectorto the transmitter connector labeled DN.2. If your transmitter is configured for two channels, connect the secondtransducer pair by repeating the above step.3. Properly configure the transmitter to work properly with your specifictransducer type. See “Programming the Transducer Parameters” onpage 67 for instructions.Important: Be sure to insert the cable connectors straight into the transmitterconnectors to avoid damaging the connectors.Figure 45: Transducer Connections (Bottom)
