Chapter 4. ProgrammingTransPort ® PT900 User’s Manual 674.5.1 Programming the Transducer ParametersTo program your transducer parameters, refer to Figure 75 on page 66 andcomplete the following steps:1. Slide the transducer type switch to either Clamp-on or Wetted, whichrefers to the method of mounting your transducers on the pipe. See Table 6below for the transducer types suitable for use with the PT900.Note: The GE Transducer Installation Guide for your transducer model providesmore detailed information on transducer mounting configurations.Table 6: Available Clamp-On TransducersTransducer Number Transducer Model Name10 C-PT-N/0.5MHz11 C-PT-N/2MHz12 C-PT-H/0.5MHz13 C-PT-H/1MHz14 C-PT-M/2MHz15 C-PT-H/0.5MHz16 C-PT-H/1MHz17 C-PT-H/2MHz23* CF-LP-H/4MHz24* CF-LP-N/4MHz31 CF-WL/2MHz401 C-RS/5MHz402 C-RS/1MHz403 C-RS/2MHz407 UTXDR/2MHz408 UTXDR/4MHz505* C-RR/0.5MHz510* C-RR/1MHz520* C-RR/2MHz591* C-RR/0.5MHz592* C-RR/1MHz601 C-AT/0.5MHz602 C-AT/1MHz603 C-AT/2MHz*the most common transducers used with the PT900
