4-14 Initial StartupSetting up the Configuration EnvironmentConnecting a Configuration Terminal to the Access ControllerFor how to connect a configuration terminal to the access controller, refer to section “ConnectingInterface Cables” on page 3-13.Setting Terminal ParametersStep1 Start the PC and run the terminal emulation program such as the Terminal of Windows 3.1 or theHyperTerminal of Windows 95/98/NT/2000/XP.Step2 Select Start > Program > Accessories > Communications > HyperTerminal. On the ConnectionDescription interface, type the name of the new connection and click OK, as shown in Figure 4-1.Figure 4-1 Connection description interfaceStep3 The system displays the Connect To interface, as shown in Figure 4-2. From the Connect usingdrop-down list, select the serial interface to be used. (Be sure to select the serial interface to which theconsole cable is actually connected.)