5-15To improve the upgrading speed, you can modify the serial interface baud rate before upgrading the file.(refer to section “Modifying Serial Interface Parameters” on page 5-8). Enter 2 on the serial submenu.The system displays the following information:Please Start To Transfer File, Press To Exit.Waiting ...CCCCCCCCCCSelect and send the application file. The procedure for upgrading an application file through a serialinterface is the same as upgrading the BootWare. For details, refer to section “Upgrading the BootWareThrough a Ethernet/Serial Interface” on page 5-7.The size of an application program is typically over 10 MB. Even at the maximum baud rate of 115200bps, the upgrade will also take a long time. Therefore, it is not recommended to upgrade applicationfiles through a serial interface but through an Ethernet interface.Upgrading Applications Through an Ethernet Interface on theBootWare MenuEnter 3 on the BootWare main menu to enter the Ethernet submenu. For details, refer to section“Ethernet submenu” on page 5-6.Configuring Ethernet Interface ParametersBefore upgrading an application program through an Ethernet interface, you need to configure theEthernet interface of the access controller, as follows:Enter 3 on the BootWare main menu to enter the Ethernet submenu. Then, enter 5 on the submenu toenter the Ethernet interface configuration interface:========================================================|Note: '.' = Clear field. || '-' = Go to previous field. || Ctrl+D = Quit. |================================================================================Protocol (FTP or TFTP) :tftpLoad File Name :host:main.binTarget File Name :target:main.binServer IP Address :192.168.0.1Local IP Address :192.168.0.10Gateway IP Address :0.0.0.0
