5-12|<1> Backup Full BootWare ||<2> Restore Full BootWare ||<3> Update BootWare By Serial ||<4> Update BootWare By Ethernet ||<0> Exit To Main Menu |===========================================================================Enter your choice(0-4):Enter 0 on the BootWare operation submenu to return to the BootWare main menu:======================================================|<1> Boot System ||<2> Enter Serial SubMenu ||<3> Enter Ethernet SubMenu ||<4> File Control ||<5> Modify BootWare Password ||<6> Skip Current System Configuration ||<7> BootWare Operation Menu ||<8> Clear Super Password ||<9> Storage Device Operation ||<0> Reboot |============================================================================Enter your choice(0-9): 0Enter 0 on the BootWare main menu to reboot the access controller.Upgrading the BootWare Through a Serial InterfaceEnter the BootWare main menu (refer to section “BootWare Main Menu” on page 5-4). On the BootWaremain menu, enter 7. The system will enter the BootWare operation submenu, where you can perform allBootWare operations. For detail description on this submenu, refer to section “BootWare operationsubmenu” on page 5-7.Enter 3 on the BootWare operation submenu to enter the BootWare operation serial submenu:============================================|<1> Update Full BootWare ||<2> Update Extend BootWare ||<3> Update Basic BootWare ||<4> Modify Serial Interface Parameter ||<0> Exit To Main Menu |================================================================================Enter your choice(0-4):Enter 4 on the BootWare operation serial submenu. The system prompts you to modify the baud rate:==================================================================|Note:'*'indicates the current baudrate || Change The HyperTerminal's Baudrate Accordingly ||----------------------------------------------------------||<1> 9600(Default)* ||<2> 19200 ||<3> 38400 ||<4> 57600 |
