H3C WX5004 Installation Manual
Also see for WX5004: Configuration guideGetting started guideInstallation guideQuick start guide
                                                                                     | |
Contents
|
4-3Figure 4-4 HyperTerminal windowStep6 Set HyperTerminal properties. Select File > Properties > Settings in the HyperTerminal to enter theproperties setting window, as shown in Figure 4-5. Select VT100 as the terminal emulation, and clickOK.Figure 4-5 Set terminal emulationPowering On the Access ControllerChecking Before Power-OnBefore powering on the access controller, verify that:z The power cord and the ground wire are properly connected.z The power supply voltage is within the range that required by the access controller.z The console cable is properly connected; the terminal (for example, a PC) used for configurationhas been started; the configuration parameters have been set. |
Related manuals for H3C WX5004
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine