H3C WX5004 Installation Manual

Also see for WX5004: Configuration guide Getting started guide Installation guide Quick start guide

A-1Appendix A Installation of Lightning Arrester forNetwork Interfacesz You can install a lightning arrester only for each 10/100 Mbps electrical Ethernet interfacesupporting RJ-45 connectors.z No lightning arrester for network interface is supplied with the access controller.If an outdoor network cable should be directly led to the access controller, to prevent possible damagesto the access controller due to lightning strike, please serially connect the lightning arrester for thenetwork interface before you plug the outdoor cable into the access controller.Toolsz Philips or flat-blade screwdriversz Multimeterz Diagonal cutting plierInstallation ProcedureStep1 Remove the protective paper on one side of the double-faced adhesive tape and stick it on the shell ofthe arrester; remove the protective paper on the other side and stick the arrester on the chassis of theaccess controller. Keep the arrester as close to the grounding screw of the access controller aspossible.Step2 Cut the ground cable of the arrester of a suitable length according to the distance between the arresterand the grounding screw and then fasten the cable on the grounding screw tightly.Step3 Use the multimeter to verify whether the ground cable of the arrester has a close touch with thegrounding screw and chassis of the access controller.Step4 Follow the instruction of the arrester to connect the arrester for network interface with a transit cable.Pay attention to the direction: IN end of the cable is connected to the arrester while OUT end of thecable is connected to the access controller. After the connection, check whether the LEDs of theinterface modules are normal.