1-11 Basic System Configuration and DebuggingCommandsz The configuration of real-time monitoring of the running status of the system is added. For thedetailed configuration, refer to section system-monitor enable.z The configuration of loading hot patch is added. For the detailed configuration, refer to sectionsdisplay patch-information, patch activate, patch delete, patch load, and patch run.z The configuration of identifying and diagnosing pluggable transceivers is added. For the detailedconfiguration, refer to sections display transceiver alarm interface, display transceiver diagnosisinterface, display transceiver interface, and display transceiver manuinfo interface.z The language-mode command is deleted.Basic System Configuration Commandsclock datetimeSyntaxclock datetime HH:MM:SS { YYYY/MM/DD | MM/DD/YYYY }ViewUser viewParametersHH:MM:SS: Current time, namely, hour:minute:second. HH ranges from 0 to 23, and MM and SS rangefrom 0 to 59.YYYY/MM/DD or MM/DD/YYYY: Current date, where YYYY represents year ranging from 2000 to 2099,MM represents month ranging from 1 to 12, and DD represents day ranging from 1 to 31.DescriptionUse the clock datetime command to set the current date and time of the Ethernet switch.By default, it is 23:55:00 04/01/2000 when the system starts up.In an implementation where exact absolute time is required, it is necessary to use this command to setthe current date and time of the Ethernet switch.After the setting, you can use the display clock command to check your configuration.
