1-6Executing the reset garp statistics command without any parameter clears the GARP statistics of allports.Related commands: display garp statistics.Examples# Clear GARP statistics of all ports. reset garp statisticsGVRP Configuration Commandsdisplay gvrp statisticsSyntaxdisplay gvrp statistics [ interface interface-list ]ViewAny viewParametersinterface interface-list: Specifies an Ethernet port list. By providing a value for this argument, you candisplay the GVRP statistics on the specified ports. You need to provide the interface-list argument in theformat of { interface-type interface-number [ to interface-type interface-number ] } &<1-10>, where theinterface-type argument represents the port type, the interface-number argument represents the portnumber, and & <1-10> means that you can provide up to 10 port indexes/port index ranges for thisargument.Note that, this command displays GVRP statistics only on the trunk ports included in the list. Statisticson non-trunk ports will not be displayed.DescriptionUse the display gvrp statistics command to display the GVRP statistics of trunk ports.This command displays the following information:z GVRP statusz Number of the GVRP entries that fail to be registeredz Source MAC address of the previous GVRP PDUz GVRP registration type of a portExamples# Display the GVRP statistics of Ethernet1/0/1, assuming that the port is a trunk port. display gvrp statistics interface Ethernet 1/0/1GVRP statistics on port Ethernet1/0/1GVRP Status : EnabledGVRP Failed Registrations : 0GVRP Last Pdu Origin : 0000-0000-0000GVRP Registration Type : Normal
