1-3Table 1-1 Description on the fields of the display interface Vlan-interface commandField DescriptionVlan-interface2 current stateThe state of the VLAN interface, which can beone of the following:z Administratively DOWN: This VLAN interfacehas been manually disabled with theshutdown command.z DOWN: The administrative state of this VLANinterface is up, but its physical state is down.It indicates that the VLAN corresponding tothis interface does not contain ports in upstate (possibly because the lines have failed).z UP: The administrative and physical states ofthis VLAN interface are both up.Line protocol current stateThe link layer protocol state of the VLANinterface, which can be one of the following:z DOWN: The protocol state of this VLANinterface is down, usually because no IPaddress is configured.z UP: The protocol state of this VLAN interfaceis up.IP Sending Frames' Format isPKTFMT_ETHNT_2Format of the frames sent from the VLANinterface. PKTFMT_ETHNT 2 indicates that thisVLAN interface sends Ethernet II frames. Referto the VLAN configuration part in theaccompanied operation manual for informationabout frame formats.Hardware address MAC address corresponding to the VLANinterfaceInternet Address IP address corresponding to the VLAN interface10.1.1.1/24 Primary Primary IP address of this VLAN interface1.1.2.1/24 Sub Secondary IP address of this VLAN interfaceDescription Description string of the VLAN interfaceThe Maximum Transmit Unit Maximum transmission unit (MTU)For information about how to configure an IP address for a VLAN interface, refer to the description onthe ip address command in the IP Address and Performance Command part.display vlanSyntaxdisplay vlan [ vlan-id1 [ to vlan-id2 ] | all | dynamic | static ]ViewAny view
