1-4Table 1-3 Description on the fields of the display ipv6 host commandField DescriptionHost Host nameAge Time for the entry to live, displayed as 0 in the case of staticconfiguration.Flags Flag indicating whether the entry is configured statically oracquired dynamicallyIPv6Address (es) IPv6 address corresponding to a host namedisplay ipv6 interfaceSyntaxdisplay ipv6 interface [ interface-type interface-number | brief ]ViewAny viewParametersinterface-type: Interface type.interface-number: Interface number.brief: Displays the brief IPv6 information of an interface.DescriptionUse the display ipv6 interface command to display the IPv6 information of a specified interface.If no interface is specified, the IPv6 information of all interfaces for which IPv6 addresses can beconfigured is displayed; if only interface-type is specified, the IPv6 information of the interfaces of thespecified type for which IPv6 addresses can be configured is displayed; if interface-typeinterface-number is specified, the IPv6 information of the specified interface is displayed.If the brief keyword is specified, the brief IPv6 information of the interface is displayed.Examples# Display the IPv6 information of a VLAN interface. display ipv6 interface Vlan-interface 1Vlan-interface1 current state :UPLine protocol current state :UPIPv6 is enabled, link-local address is FE80::2E0:FCFF:FE00:CGlobal unicast address(es):2008::5600, subnet is 2008::/64Joined group address(es):FF02::1:FF00:5600FF02::1:FF00:CFF02::1MTU is 1500 bytesND DAD is enabled, number of DAD attempts: 5
