1 - 104. Using the cordless scanner, scan the Association Bar Code (the bar codelabel on the top of the base) to link that scanner to the base.Two quick beeps followed by clicking, then a single beep indicates a “good”association. The scanner is in communication with the base. If the scannerclicks for 30 seconds and signals an error (triple beep), it has not associated withthe base.Note: If the charge pack is removed from the scanner and replaced afterassociation, the scanner automatically reassociates to the base, if thebase has power. In this case, the scanner beeps when a charged chargepack is installed, then beeps a second time after full association, typicallyfive to ten seconds later.Note: A scanner always defaults to work group 0 after scanning a base I.D. barcode.5. After your cordless scanner has been associated with its base unit, programthe system to work with your terminal or computer by scanning the TerminalSetup Codes. Use the Supported Terminal list (page 2-6) to scan your termi-nal’s Terminal ID.With Plug and Play programming, you scanonly one bar code to program thecordless system to work with a designated interface, including any requiredprefixes and suffixes.6. To determine if your cordless system is set up correctly, scan one of thesample bar codes in the back of this manual.Linear Imager orLaser ScannerCordless BaseAssociation Bar Code
