Hand Held Products Scanteam 2070 System Manual

Also see for IMAGETEAM 3870: Quick start

Contents

3 - 28Aux Data FormatterWhen Aux Data Formatter is turned off, the data coming into the aux port isoutput to the host as received (including prefixes and suffixes). When Aux DataFormatter is required, all incoming data must conform to an edited format or thebase does not transmit the input data to the host device. If this occurs, the datais discarded.Default = Aux Data Formatter On, but Not Required.Alternate Aux Data FormatsAlternate formats allow you “single shot” capability to edit incoming data using adifferent aux data format than your primary aux format. When aux data formatsare programmed (see page 3-18), you must input whether you are programmingthe primary aux format, or an alternate format numbered 1, 2, or 3.An alternate aux format is initiated by scanning one of the 3 alternate aux formatbar codes below. The base will edit the incoming data, formatting the data withthe selected alternate aux format, then revert immediately to the primary auxformat.Aux Data Formatter Off*Aux Data Formatter On andRequired*Aux Data Formatter On,but Not RequiredAlternate Aux Data Format 2Alternate Aux Data Format 3Alternate Aux Data Format 1