3. Assemble the Remote Supervisor Adapter II SlimLine and Interposer card:ConnectorInterposer cardMounting holeStandoffsRemote SupervisorAdapter II SlimLineMounting holeStandoffsStandoffsa. Insert the standoffs that come with the option into the mounting holes in theRemote Supervisor Adapter II SlimLine.b. Align the mounting holes in the Interposer card with the standoffs; then,align the connector on the card with the connector on the RemoteSupervisor Adapter II SlimLine.c. Press the Interposer card and Remote Supervisor Adapter II SlimLinetogether until fastened.4. Press the Remote Supervisor Adapter II SlimLine Guide into place on thesystem board.Remote Supervisor Adapter IISlimLine guideRemote Supervisor Adapter IISlimLineRemote Supervisor Adapter IISlimLine connector5. Position the entire assembly so that the edge connector on the Interposer cardis at the rear of the server.6. Carefully grasp the assembly by its top edge or upper corners, and align it withthe Remote Supervisor Adapter II SlimLine Guide and the connector on thesystem board.Attention: Incomplete insertion might cause damage to the system board orthe adapter.7. Press the assembly firmly into the connector and under the retention latch onthe Remote Supervisor Adapter II SlimLine Guide.30 xSeries 236 Type 8841: Hardware Maintenance Manual and Troubleshooting Guide
