10. Remove the panel, carefully threading the cable past the other componentsand through the opening in the chassis.Note: If the cable has been secured in the cable clamps, gently pull it out ofthe clamps before pulling the cable through the opening in the chassis.To install the operator information panel, reverse the previous steps.Notes:1. Thread the cable through the opening in the chassis and extend it into theserver before attaching the operator information panel.2. Secure the cable in the cable clamps along the inside of the chassis.3. Fit the left tab (in the rack configuration, this is the top tab) into the lip on thechassis, and then press on the right tab (in the rack configuration, this is thebottom tab) until it snaps into place.60 xSeries 236 Type 8841: Hardware Maintenance Manual and Troubleshooting Guide
