DANGERTo prevent a possible electrical shock when adding or removing any devices to or from the system, ensurethat the power cords for those devices are unplugged before the signal cables are connected ordisconnected. If possible, disconnect all power cords from the existing system before you add or remove adevice. (RSFTD203)DANGERTo prevent a possible electrical shock during an electrical storm, do not connect or disconnect cables orstation protectors for communications lines, display stations, printers, or telephones. (RSFTD003)DANGERTo prevent a possible electrical shock, do not use the port tester during electrical storms. (RSFTD006)DANGERTo prevent a possible electrical shock from touching two surfaces with different electrical grounds, use onehand, when possible, to connect or disconnect signal cables. (RSFTD004)DANGERTo prevent power from switching on automatically during service procedures, select manual or secure modeon the system unit control panel or disconnect the cables that connect to J15 and J16 on the frame beingserviced. (RSFTD211)Read and understand the following service procedures before using this section:v Power on/off the system and logical partitionsv Determining a Primary or Alternative Console in the iSeries Service Functions informationWS-PIP1: Note: If the console has a keyboard error, there may be a K on the display. See theworkstation service information for more information.1. If the system has logical partitions, perform this procedure from the logical partition that reported theproblem. To determine if the system has logical partitions, go to Determine if the system has logicalpartitions.2. Are you using a workstation adapter console (type 6A58 or 6A59)?v No: Continue with the next step.v Yes: Go to “WSAC-PIP1” on page 248.This ends the procedure.3. Perform the following:a. Select the icon on the workstation to make it the console (you may have already done this). Youmust save the console selection. For more information see Local Device Configuration and LAN,Frame-Relay and ATM Support.b. Access dedicated service tools (DST) by performing the following:1) Select Manual mode on the control panel.2) Use the selection switch on the control panel to display function 21, Make DST Available, andpress Enter on the control panel.3) Wait for a display to appear on the console or for a reference code to appear on the controlpanel.Analyze hardware problems 245
