Table 13. For FC 5078, FC 0578, FC 5088, or FC 0588 I/O frameUnit reference code FRU7610, 7611 1. AMD B022. Cable (part 51L5652)3. AMD controller card BB17620, 7621 1. AMD B022. Cable (part 51L5652)3. AMD controller card BB17630, 7631 1. AMD B012. Cable (part 51L5652)3. AMD controller card BB17640, 7641 1. AMD B012. Cable (part 51L5652)3. AMD controller card BB1Table 14. For FC 5095Unit reference code FRU7610, 7611 AMD B017620, 7621 AMD B027630, 7631 AMD B037640, 7641 AMD B04This ends the procedure.AJDGP01Licensed Internal Code is the failing item. Look for PTFs associated with the reference code and have thecustomer apply them.ALTINTFFor use by authorized service providers.The failing item is any card, cable or card enclosure connected to Bus 1 that might cause an interfacefailure between the service processor and the alternate IPL load-source device.1. Check the load source device unit to ensure it is ready.2. Verify that the load source media (tape or compact disk) is loaded properly and is a valid IPL media.3. Power off the system from the control panel.4. Perform the following:a. Check cable connections:v For Models 270 and 820, check the cables and connections between the system unitbackplane and the storage device units.v For Models 830, 840, SB2, and SB3, check the cables and connections between the systemunit and the base I/O tower.b. Reseat cables where possible.c. Change the IPL mode to Manual, and the IPL speed to SLOW OVERRIDES using control panelfunction 2.d. Power on the system.Does the same SRC occur?274 iSeries: iSeries Server 270, 800, 810, 820, 825, 830, 840, 870, 890, SB2, and SB3 Hardware Problem Analysis andIsolation
