4. Press down on blue touch points on the PCI riser-card assembly to install theassembly in the server. Make sure that the PCI riser-card assembly is fullyseated in the PCI connectors on the system board.Attention: Make sure that the cables are not pinched.5. Install the server cover (see “Installing the cover” on page 146).6. Reconnect the external cables; then, reconnect the power cords and turn on theperipheral devices and the server.Removing a riser card on the PCI riser-card assemblyTo remove a PCI riser card from the PCI riser-card assembly, complete thefollowing steps:1. Read the safety information that begins on page vii and “Installation guidelines”on page 133.2. Turn off the server and peripheral devices and disconnect all power cords andexternal cables.3. Remove the server cover (see “Removing the cover” on page 145).4. Remove the PCI riser-card assembly (see “Removing the PCI riser-cardassembly” on page 150).5. Remove any adapter on the PCI riser-card assembly (see “Removing anadapter from the PCI riser-card assembly” on page 156).6. If you are removing PCI riser card 2 that contains the PCI Express Gen 2 x8connector, you may remove the remote battery trays to obtain more room (seestep 5 on page 170 of the “Removing a ServeRAID controller battery from theremote battery tray” on page 170 procedure).7. Loosen the screws that secure the PCI riser card to the PCI riser-cardassembly.The following illustration shows how to remove PCI riser card 1 from the PCIriser-card assembly:152 IBM System x3630 M3 Type 7377: Problem Determination and Service Guide
