v LSI Configuration Utility programUse the LSI Configuration Utility program to configure the integrated SAS/SATAcontroller with RAID capabilities and the devices that are attached to it. Forinformation about using this program, see “Using the Setup utility.”The following table lists the different server configurations and the applicationsthat are available for configuring and managing RAID arrays.Table 15. Server configuration and applications for configuring and managing RAID arraysServer configurationRAID array configuration(before operating system isinstalled)RAID array management(after operating system isinstalled)ServeRAID-BR10il v2adapter (LSI 1064E)LSI Utility (Setup utility, pressCtrl+C), ServerGuideMegaRAID Storage Manager(MSM), DirectorServeRAID-M5014 adapter(LSI SAS2108)MegaRAID BIOSConfiguration Utility,ServerGuideMegaRAID Storage Manager(MSM), DirectorServeRAID-M5015 adapter(LSI SAS2108)MegaRAID BIOSConfiguration Utility,ServerGuideMegaRAID Storage Manager(MSM), DirectorServeRAID-M1015 adapter(LSI SAS2008)MegaRAID BIOSConfiguration Utility,ServerGuideMegaRAID Storage Manager(MSM), Directorv IBM Advanced Settings Utility (ASU) programUse this program as an alternative to the Setup utility for modifying serverfirmware settings and IMM settings. Use the ASU program online or out of bandto modify server firmware settings from the command line without the need torestart the server to access the Setup utility. For more information about usingthis program, see “IBM Advanced Settings Utility program” on page 251.Using the Setup utilityUse the Setup utility, formerly called the Configuration/Setup Utility program, toperform the following tasks:v View configuration informationv View and change assignments for devices and I/O portsv Set the date and timev Set the startup characteristics of the server and the order of startup devicesv Set and change settings for advanced hardware featuresv View, set, and change settings for power-management featuresv View and clear error logsv Resolve configuration conflictsStarting the Setup utilityTo start the Setup utility, complete the following steps:1. Turn on the server.Note: Approximately 40 seconds after the server is connected to ac power, thepower-control button becomes active.2. When the prompt Setup is displayed, press F1. If you have set anadministrator password, you must type the administrator password to access thefull Setup utility menu. If you do not type the administrator password, a limitedSetup utility menu is available.Chapter 6. Configuration information and instructions 235
