IBM x3630 M3 7377 Problem Determination And Service Manual

Also see for x3630 M3 7377: Specification Product guide

Contents

9. Reconnect the external cables; then, reconnect the power cords and turn on theperipheral devices and the server.Removing a ServeRAID controller from the PCI riser-card assemblyTo remove a ServeRAID controller from the PCI riser-card assembly, complete thefollowing steps:1. Read the safety information that begins on page vii and “Installation guidelines”on page 133.2. Turn off the server and peripheral devices and disconnect all power cords andexternal cables.3. Remove the cover (see “Removing the cover” on page 145).4. Remove the PCI riser-card assembly (see “Removing the PCI riser-cardassembly” on page 150).5. Disconnect the SAS signal cables from the connectors on the ServeRAIDcontroller and note their locations.6. Remove the ServeRAID controller:a. If you are removing the ServeRAID controller from expansion slot 3 or 4 onthe PCI-riser-card assembly, rotate the retention latch on the rear of the PCIriser-card assembly to the open position.b. Carefully grasp the ServeRAID controller by its top edge or upper corners,and pull the adapter from the expansion slot.7. If you are instructed to return the ServeRAID controller, follow all packaginginstructions, and use any packaging materials for shipping that are supplied toyou.Installing a ServeRAID controller on the PCI riser-card assemblyChapter 5. Removing and replacing server components 159