IBM x3630 M3 7377 Problem Determination And Service Manual

Also see for x3630 M3 7377: Specification Product guide

Contents

2. Turn off the server and peripheral devices and disconnect all power cords andexternal cables.3. Remove the cover (see “Removing the cover” on page 145).4. (For 3.5-inch hard disk drive models only) Remove the signal cables.5. Grasp the system fan cage by the blue grip points.6. Press the retention latches toward each other; then, lift the system fan cage outof the server.7. If you are instructed to return the system fan cage, follow all packaginginstructions, and use any packaging materials for shipping that are supplied toyou.Installing the system fan cageFor proper cooling, the server requires that all fans in the server be operating at alltimes.Attention:v To ensure proper server operation, if a fan fails, replace the fan immediately.v Make sure the power cable on the backplane is well-routed so it will not block thefan cage while installing.To install the system fan cage, complete the following steps:1. Align the system fan cage with the guide rails on the fan cage bracket.2. If you have removed any cable(s), connect them all except the signal cable.3. Lower the system fan cage into the fan cage bracket until the system fan cageclicks into place.Notes:a. Make sure no cables are pinched.b. (For 3.5-inch hard disk drive models only) It will be easier for the installationif you temporary remove the power cable on the hot-swap backplane.Chapter 5. Removing and replacing server components 191