Icom IC-2200H Instruction Manual

Also see for IC-2200H: Service manual Instruction manual Addendum Service manual Instruction manual

Contents

Icom IC-2200H Instruction Manual Manual pdf 34 page image

Offset frequencyWhen communicating thorough a repeater, the transmit fre-quency is shifted from the receive frequency by an amountdetermined by the offset frequency.q Push [SET ] to enter set mode.w Push [SET] or [MONI] until “±” and offset frequency appear.e Rotate [DIAL] to set the desired offset frequency.• Push [V/MHz] to select the 1 MHz tuning steps.r Push any key other than indicated function keys to exitset mode.z Push [ SET B(D-OFF)] to enter set mode.x Push [SET B(D-OFF)] or [ENT C(T-OFF)] until “±”and offset frequency appear.c Push [YY] or [ZZ] to set the desired offset.• Direct frequency entry from the keypad is not possi-ble.v Push [ CLR A(MW)] to exit set mode. Repeater lockoutThis function helps prevent interference to other stations byinhibiting your transmission when a signal is received. Thetransceiver has two inhibiting conditions, repeater and busy.q Push [PWR] to turn power OFF.w While pushing [SET ], turn power ON to enter ini-tial set mode.e Push [SET] or [MONI] several times until the “RLO” dis-play appears as shown below.r Rotate [DIAL] to turn the repeater lockout function to “RP,”“BU” or OFF.• “RP”: Transmit is inhibited when a signal with un-matched sub-audible tone is received.• “BU”: Transmit is inhibited when a signal is received.t Push [PWR] to exit initial set mode.LOCKS E TANMMONIDUPLOWT-SCANTONEPRIOM/CALLSCANV/MHzDIGITAL PRIO AO BUSYMUTENARMIDLOWLOCKS E TANMMONIDUPLOWT-SCANTONEPRIOM/CALLSCANV/MHzDIGITAL PRIO AO BUSYMUTENARMIDLOW[PWR] [SET LOCK ]LOCKUSING INITIAL SET MODELOCKS E TANMMONIDUPLOWT-SCANTONEPRIOM/CALLSCANV/MHzDIGITAL PRIO AO BUSYMUTENARMIDLOWPushSETBLOCKS E TANMMONIDUPLOWT-SCANTONEPRIOM/CALLSCANV/MHzDIGITAL PRIO AO BUSYMUTENARMIDLOW[DIAL]LOCKUSING SET MODE214 REPEATER OPERATION