Icom IC-2200H Instruction Manual

Also see for IC-2200H: Service manual Instruction manual Addendum Service manual Instruction manual

Contents

Icom IC-2200H Instruction Manual Manual pdf 72 page image

5912 DIGITAL MODE OPERATIONYour call sign programming—continuedz Push [BANK/OPTION] for 1 sec. thenpush [BANK/OPTION] or [MR/CALL] toselect the call sign select mode.• “MYC” appears.x Push [YY] or [ZZ] to select the desired callsign channel then push [ SET B(D-OFF)].c Push [ SET B(D-OFF)] to set into call signprogramming mode.• The 1st digit blinks and channel indicationstops blinking.v Push [YY] or [ZZ] to set the desired charac-ter or code.• Push [ SET B(D-OFF)] or [ ENT C(T-OFF)] tomove the cursor to left or right, respectively.b Push [SET B(D-OFF)] or [ENT C(T-OFF)] toselect 2nd digit, then push [YY] or [ZZ] to setthe desired character or code.• 2nd digit blinks (1st digit stops blinking).• Repeat this step for programming your callsign.n Push [ CLR A(MW)] to fix the call sign andexit programming condition.DD Station/Repeater1/2 call sign programmingStation call sign must be programmed for the specified sta-tion call as well as repeater operation in both Digital voice andslow data communications.q Push [BANK ] for 1 sec. then push [BANK ] or[V/MHz] several times to select the call sign select mode.• “YUC” appears for station call sign.• “R1C” or “R2C” appears for repeater call sign.w Rotate [DIAL] to select the desired call sign channel thenpush [SET] or [MONI].e Push [MONI] (or [SET]) to set into call sign programming con-dition.• The 1st digit blinks and channel indication stops blinking.r Rotate [DIAL] to set the desired character or code.• Push [MONI] or [SET] to move the cursor to left or right, re-spectively.LOCKS E TANMMONIDUPLOWT-SCANTONEPRIOM/CALLSCANV/MHzDIGITAL PRIO AO BUSYMUTENARMIDLOWLOCKS E TANMMONIDUPLOWT-SCANTONEPRIOM/CALLSCANV/MHzDIGITAL PRIO AO BUSYMUTENARMIDLOWOPTOPTBANK/OPTION