Icom IC-2200H Instruction Manual

Also see for IC-2200H: Service manual Instruction manual Addendum Service manual Instruction manual

Contents

Icom IC-2200H Instruction Manual Manual pdf 64 page image

5110 POCKET BEEP AND TONE SQUELCH Tone scanBy monitoring a signal that is being operated with pocketbeep, tone or DTCS squelch function, you can determine thetone frequency or DTCS code necessary to open a squelch.q Set the channel to be checked for a tone frequency orcode.w Push [TONE ] several times to select the tonecondition or type to be scanned.• One of “ ,” “ ” or “ ” appearse Push [TONE ] for 1 sec. to start the tone scan.• To change the scanning direction, rotate [DIAL].r When the CTCSS tone frequency or 3-digit DTCS code ismatched, the squelch opens and the tone frequency istemporarily programmed into the selected condition suchas memory or call channel.• The tone scan pauses when a CTCSS tone frequency or 3-digitDTCS code is detected.• The decoded CTCSS tone frequency or 3-digit DTCS code isused for the tone encoder or tone encoder/decoder dependingon the selected tone condition or type in step w.- No indication : Cannot be used for operation.- “ ” : CTCSS tone encoder- “ ” : CTCSS tone encoder/decoder- “ ” : DTCS tone encoder/decodert Push [V/MHz ] to stop the scan.z Set the channel to be checked for a tone fre-quency.x Selects the tone condition or type to bescanned.• Push [FUNC] then push; [ DUP– 7(TONE)] for re-peater tone; [ SIMP 9(TSQL)] for tone squelch;[HIGH 4(DTCS)] for DTCS squelch.c Push [FUNC] then [ SCAN 2(T-SCAN)] to startthe tone scan.v When the tone frequency is matched, thesquelch opens and the tone frequency is pro-grammed into the selected mode such asmemory or call channel.b Push [ CLR A(MW)] to stop the scan.T-SCANSCANLOCKS E TANMMONIDUPLOWT-SCANTONEPRIOM/CALLSCANV/MHzDIGITAL PRIO AO BUSYMUTENARMIDLOWLOCKS E TANMMONIDUPLOWT-SCANTONEPRIOM/CALLSCANV/MHzDIGITAL PRIO AO BUSYMUTENARMIDLOWLOCKS E TANMMONIDUPLOWT-SCANTONEPRIOM/CALLSCANV/MHzDIGITAL PRIO AO BUSYMUTENARMIDLOWDuring CTCSS tone scan During DTCS code scanT-SCANT-SCANNOTE: The decoded tone frequency is programmed tem-porarily when a memory or call channel is selected. How-ever, this will be cleared when the memory/call channel isre-selected.