8413OTHER FUNCTIONS13 Microphone keysThe supplied HM-133V’s (optional for some versions) [F-1]and [F-2] keys memorize the transceiver conditions.The [UP]/[DN] keys of the standard or an optional micro-phone (other than the HM-133V) can be assigned functionslike the function keys on the transceiver’s front panel.DD [F-1]/[F-2] keys on HM-133VThe following conditions can be memorized into [F-1] and[F-2] keys, independently.• Operating frequency• Repeater setting (offset direction and frequency, toneON/OFF and frequency)• Tone/DTCS squelch (ON/OFF, frequency/code and polarity)• Transmit output power selection• Set mode settings• Initial set mode settings (except display type item)➥ Programming the conditionSet the desired contents of each condition,then push [F-1]/[F-2] for 1 sec.• 3 beeps sound.➥ Re-calling the conditionPush [F-1]/[F-2] momentarily.DD [UP]/[DN] keys on a microphones(other than HM-133V)The following functions are assigned to the [UP]/[DN] keyson the other microphones (HM-118N/TAN, etc.) when first ap-plying power.[UP] : channel up; push and hold to start scan, push againto stop scan.[DN] : channel down; push and hold to start scan, pushagain to stop scan.➥ Assigning a functionq Turn the power OFF.w While pushing the desired key on the transceiver and oneof either [UP]/[DN] keys on the microphone, turn thepower ON.• The function is programmed into the key.➥ Clearing an assignmentq Turn the power OFF.w While pushing the desired [UP] or [DN] key on the micro-phone, turn the power ON.AT POWER ON[F-1]/[F-2]

i supplied accessories

quick reference guide

battery connection

antenna installation

Turning ON transceiver

i repeater operation

I Front panel

I Function display

I Rear panel

I Microphone keypad

I Preparation

I Using the keypad

I Tuning step selection

I Lock functions

BASIC OPERATION

I Audio mute function

I S-meter squelch

I Selecting output power

REPEATER OPERATION

I Subaudible tones

I Offset frequency

I Reversed duplex mode

I Auto repeater

MEMORY OPERATION

I Programming a memory channel

programming a memory channel via the microphone

I Transferring memory contents

I Programming channel names

I Memory clearing

I Memory bank selection

I Memory bank setting

I Transferring bank contents

CALL CHANNEL OPERATION

I Programming a call channel

SCAN OPERATION

I Scan start/stop

I Scan edges programming

I Skip channel setting

I Scan resume condition

priority watch

i priority watch operation

i programming a dtmf code

i transmitting a dtmf code

i pocket beep operation

tone scan

I Code programming

i pager operation

I Code squelch

I Digital mode operation

digital mode operation

i digital voice mode operation

I When receiving a Digital call

I Emergency communication

I Slow data communication

I GPS operation

other functions

I Initial set mode

i weather channel operation

i microphone keys

i data cloning

specifications

troubleshooting

i fuse replacement

i optional unit installation

mode arrangement

Icom IC-2200H Instruction Manual

IC-2200H

HM-133V

LOGIC unit;

MAIN unit;

pll circuits

port allocations

parts list

HM-118TN

INSIDE VIEW

MECHANICAL PARTS LIST AND DISSASEMBLY

BOARD LAYOUT

SEMI-CONDUCTOR INFORMATION

receiver circuits

transmitter circuits

power supply circuits

main unit

receive adjustments