427SCAN OPERATION7 Scan resume conditionThe scan resume condition can be selected as timer or pausescan. The selected resume condition is also used for prioritywatch. (p. 44)q Push [SET ] to enter set mode.w Push [SET] or [MONI] several times until “SCT” or “SCP”appears as shown above.• When “d” is displayed in place of the 100 MHz digit, cancel theDTMF memory encoder in advance. (p. 46)e Rotate [DIAL] to set the desired timer:• “SCT-15” : Scan pauses 15 sec. while receiving a signal.• “SCT-10” : Scan pauses 10 sec. while receiving a signal.• “SCT-5” : Scan pauses 5 sec. while receiving a signal.• “SCP-2” : Scan pauses until the signal disappears and thenresumes 2 sec. later.r Push any keys than [SET] or [MONI] to exit set mode.z Push [ SET B(D-OFF)] to enter set mode.x Push [SET B(D-OFF)] or [ENT C(T-OFF)] severaltimes until “SCT” or “SCP” appears as shown atleft.c Push [YY] or [ZZ] to select the scan resume condi-tion.• See item e at left for scan resume condition details.v Push [ CLR A(MW)] to exit set mode.NOTE:Set mode cannot be accessed when memory names aredisplayed. To set the scan resume condition, return to fre-quency indication by pushing [MONI ] on the frontpanel for 1 sec., or push [FUNC] then [MONI 1(ANM)] (HM-133V) to cancel the channel name indication, then set asdescribed on this page.ANMSETBUSING SET MODELOCKLOCKS E TANMMONIDUPLOWT-SCANTONEPRIOM/CALLSCANV/MHzDIGITAL PRIO AO BUSYMUTENARMIDLOWThe display shows thatthe scan will resume15 sec. after it stops.

i supplied accessories

quick reference guide

battery connection

antenna installation

Turning ON transceiver

i repeater operation

I Front panel

I Function display

I Rear panel

I Microphone keypad

I Preparation

I Using the keypad

I Tuning step selection

I Lock functions

BASIC OPERATION

I Audio mute function

I S-meter squelch

I Selecting output power

REPEATER OPERATION

I Subaudible tones

I Offset frequency

I Reversed duplex mode

I Auto repeater

MEMORY OPERATION

I Programming a memory channel

programming a memory channel via the microphone

I Transferring memory contents

I Programming channel names

I Memory clearing

I Memory bank selection

I Memory bank setting

I Transferring bank contents

CALL CHANNEL OPERATION

I Programming a call channel

SCAN OPERATION

I Scan start/stop

I Scan edges programming

I Skip channel setting

I Scan resume condition

priority watch

i priority watch operation

i programming a dtmf code

i transmitting a dtmf code

i pocket beep operation

tone scan

I Code programming

i pager operation

I Code squelch

I Digital mode operation

digital mode operation

i digital voice mode operation

I When receiving a Digital call

I Emergency communication

I Slow data communication

I GPS operation

other functions

I Initial set mode

i weather channel operation

i microphone keys

i data cloning

specifications

troubleshooting

i fuse replacement

i optional unit installation

mode arrangement

Icom IC-2200H Instruction Manual

IC-2200H

HM-133V

LOGIC unit;

MAIN unit;

pll circuits

port allocations

parts list

HM-118TN

INSIDE VIEW

MECHANICAL PARTS LIST AND DISSASEMBLY

BOARD LAYOUT

SEMI-CONDUCTOR INFORMATION

receiver circuits

transmitter circuits

power supply circuits

main unit

receive adjustments