8611TONE SQUELCH AND POCKET BEEP12345678910111213141516171819■ Tone/DTCS squelch beep operationqSet the desired operating frequency and the desired oper-ating mode.wSet the desired CTCSS tone or DTCS code.ePush [TONE•DTMF] several times to select the desiredsquelch system• “T SQL ”: Tone squelch with pocket beep; “DTCS ”: DTCSsquelch with pocket beep; “T SQL”: Tone squelch; “DTCS”:DTCS squelchrWhen a signal with the correct tone or code is received, thetransceiver’s mute is released and received audio sounds.• Emits beep tones for 30 sec. and blinks “ ” if pocket beep is se-lected in step e.tPush [PTT] to answer or push [MAIN•BAND] to stop thebeeps and blinking.z Set the operating frequency.x Push [FUNC] then push one of following keysto turn the desired squelch system ON.• [HIGH 4(DTCS)] : DTCS squelch• [MID 5(DTCSS)] : DTCS squelch with pocketbeep• [ DUP + 8(TSQLS)] : Tone squelch with pocketbeep• [ SIMP 9(TSQL)] : Tone squelchc When a signal with the correct tone or code isreceived, the transceiver’s mute is releasedand received audio sound.• Emits beep tones for 30 sec. and blinks “ ” ifpocket beep is selected in step e.v Push [PTT] to answer or push [CLR A(MW)] tostop the beeps and blinking.• “ ” disappears and cancels the pocket beep func-tion automatically.b To cancel the tone squelch or DTCS squelchfunction, push [FUNC] then [ENT C(T-OFF)].• “TSQL” or “DTCS” disappearsTSQLSDTCSSPocket beep DTCS beepNOTE:• The DTCS squelch operation on sub band does not func-tion during DTCS transmission because the same en-coder/decoder circuit is being used for both main and subbands. Tone squelch operation on sub band may not beperformed correctly during DTCS transmission.• The tone/DTCS code squelch opens sometimes whenother stations communicate using an adjacent tone fre-quency or in a DTCS code.• The tone/DTCS code squelch can be operated on FM orFM-N mode only.
