344REPEATER OPERATION12345678910111213141516171819■ Offset frequencyWhen communicating through a repeater, the transmit fre-quency is shifted from the receive frequency by an amountdetermined by the offset frequency.Independent offset frequencies can be set for each operatingfrequency band.qPush [MAIN•BAND] to select the desired band (left or right)as the main band.wSelect the desired mode/channel you wish to set the offsetfrequency for, such as VFO mode or memory/call channel.ePush [F• ] to display the function guide then push[MENU](V/MHz•SCAN) (Right band’s) to enter MENUscreen.rRotate [DIAL] to select “ DUP/TONE… ” , then push[MAIN•BAND].tRotate [DIAL] to select “OFFSET FREQ” item, then push[MAIN•BAND].yRotate [DIAL] to set the desired offset frequency.• Push [MHz](V/MHz•SCAN) (Left band’s) to turn 1 MHz tuningON and OFFuPush [BACK](V/MHz•SCAN) (Right band’s) twice to exitDUP/TONE set mode.z Push [BAND] to select the desired band (left orright) as the main band.• Enter the desired frequency via the keypad if neces-sary.x Select the desired mode/channel you wish toset the offset frequency for, such as VFO modeor memory/call channel.• The offset frequency can be independently pro-grammed into each mode or channel.c Push [SET B(D-OFF)] to enter MENU screen.v Push [Y] or [Z] to select “DUP/TONE…” thenpush [SET B(D-OFF)].b Push [Y] or [Z] to select “OFFSET FREQ” thenpush [SET B(D-OFF)].n Push [Y] or [Z] to set the desired offset.• Direct frequency entry from the keypad is not possi-ble.m Push [CLR A(MW)] to exit set mode.NOTE: The offset frequency can be set in amemory/call channel temporarily. However, theset frequency is cleared once another memorychannel or VFO mode is selected. To store theoffset frequency permanently, overwrite thechannel information.SETB[MENU][F• ][DIAL][MAIN•BAND]
