Icom IC-RX7 Instruction Manual

Also see for IC-RX7: Price list Instruction manual Instruction manual Service manual Service manual addendum

Contents

Icom IC-RX7 Instruction Manual Manual pdf 58 page image

507 MEMORY PROGRAMMINGNew2001■ Memory channel programmingq Push and hold [HOLD V] for 1 sec. to select VFO mode.w Set the desired frequency, if desired:• Frequency or any other data can be set while in CH program-ming state.➥ Select the desired band with [v] or [w].➥ Set the desired frequency with [DIAL].➥ Or set the desired frequency with keypad directly.In this case, the band and frequency settings with[v]/[w] and [DIAL] as above are not required.➥ Set other data (e.g. offset frequency, duplex direction,tone squelch, etc.) in the menu screen.e Push and hold [ENT MW] for 1 sec. to enter the memoryprogramming mode.• 1 short and 1 long beep sound.• Category selection screen appears.✔ STORING SEARCHED FREQUENCY:Another way to store information into memory channels is asfollows:q Start a search.• Search pauses when a signal is received.• Rotate [DIAL] to restart the search.w Push [HOLD V] to hold the search, if you want to store thepaused frequency into memory channel.e Push and hold [ENT MW] for 1 sec. to enter the memoryprogramming mode.rPush [r] or [s] (or rotate [DIAL]) to select the desiredcategory or “ADDITION,” then push [ENT MW].• When “ADDITION” is selected, new category can be pro-grammed (see p. 52 for new category programming details).t Push [r] or [s] (or rotate [DIAL]) to select the desiredgroup or “ADDITION,” then push [ENT MW].• When “ADDITION” is selected, new group can be programmedin the category (see p. 53 for new group programming details).NOTE: The previous selected category or group areselected automatically when two or more memory channelsare programmed continuously.