557MEMORY PROGRAMMINGNew200112345678910111213141516171819D New CH programmingq Push [r] or [s] (or rotate [DIAL]) to select the desiredinformation.Selectable information:• FREQ • DUP • OFFSET • TS• MODE • ATT • SKIP • PRIO• STOP BEEP • TONE • TSQL FREQ • DTCS CODE• DTCS P • VSCFREQ, OFFSETq Push [ENT MW] (or [w]) to enter the frequency input.w Edit the desired frequency with keypad (pgs. 20, 21).Other information(DUP, TS, MODE, ATT, SKIP, PRIO, STOP BEEP, TONE,TSQL FREQ, DTCS CODE, DTCS P, VSC)q Push [ENT MW] (or [w]) to edit the setting state.w Push [r] or [s] to select the desired setting, thenpush [ENT MW].wPush and hold [ENT MW] for 1 sec. to program the chan-nel and return to the frequency indication.• 1 short and 1 long beep sound.■ Memory channel selectionMemory channel can be selected during scan holding state.q Push [SCAN] to start a scan, then push [HOLD V] to holdthe scan.wPush and hold [v] or [w] for 1 sec. to select the desiredcategory.ePush [No. DIAL] and the assigned number to call the de-sired memory name in the category directly.• If the memory number is not assigned to the memory name,skip this step. (See p. 54 for number programming details.)When the assigned number is 0 to 9;➥ Push a number then push [ENT MW] to call the number.When the assigned number is 00 to 99;➥ Push 2 digit number then push [ENT MW] to call the number.When the assigned number is 000 to 999;➥ Push 3 digit number to call the number.NO. 4NO. 24NO. 127MWENT4MWENT421 72r Rotate [DIAL] to select the channel.