JBL AV2 User Manual

Also see for Control Series: Assembly instruction guide Owner's guide Owner's manual Owner's guide Owner's manual

Contents

JBL AV2 User Manual Manual pdf 106 page image

Appendix C Harman Consumer Group, Inc.C-121. On the remote control, press and hold the MAIN and ENT (Enter)buttons at the same time. After about three seconds, “SETUP” isdisplayed in the Menu name area at the top of the LCDtouchscreen. This is the Setup mode of the remote control.NOTE: You now have 30 seconds to perform the next step while theremote is in the Setup mode. If a button is not pressed within 30seconds, the SETUP menu name will revert to MAIN, indicating thatthe remote control is no longer in Setup mode. If this occurs, you willneed to repeat this step to re-enter the Setup mode.2. Touch the EDIT option to add and hide touchscreen menu pages.The menu name changes to “EDIT” and the bottom of the screenflashes “SELECT BUTTON”.A new screen now displays with the options: TEXT, PAGE andEXIT. Touching the EXIT option will leave the menu withoutsaving any changes.Note: The TEXT option allows the text of each menu to be changed.Refer to the “Customizing the Touchscreen” procedure, found earlierin this chapter, for instructions.3. Touch the PAGE option. The menu name changes to “PAGE” andthe component options are displayed. The bottom of the touchscreen flashes “SELECT”.4. Navigate to the menu and page that you want to HIDE or ADD.When you select a page, the top of the screen indicates whetheryou want to “ADD?” or “HIDE?” the displayed page.5. When you’re ready to change a page’s visibility, to ADD or HIDE it,press the Light button.6. Repeat Steps 4 and 5 to ADD or HIDE any menu pages desired onother components or the favorites pages.7. When finished, exit the Setup mode by pressing the Main buttonuntil the touchscreen displays MAIN in the menu heading area.The remote control is in normal operation mode again.ERASING COMMANDSYou can erase an individual button with a learned command, a macroor a favorite channel. You can erase an ENTIRE component’s learnedcommand or macro buttons. You can also erase ALL of your learnedcommands on ALL components, or all your macros and favoritechannels everywhere.Note: To erase everything and return the remote control to its factorydefault settings, refer to the “Restoring Factory Default Settings”procedure, which follows this secton.1. On the remote control, press and hold the MAIN and ENT (Enter)buttons at the same time. After about three seconds, “SETUP” isdisplayed in the Menu name area at the top of the LCDtouchscreen. This is the Setup mode of the remote control.NOTE: You now have 30 seconds to perform the next step while theremote is in the Setup mode. If a button is not pressed within 30seconds, the SETUP menu name will revert to MAIN, indicating thatthe remote control is no longer in Setup mode. If this occurs, you willneed to repeat this step to re-enter the Setup mode.2. Touch the ERASE option to erase learned buttons, macros orfavorite channels. The menu name changes to “ERASE” and thebottom of the screen flashes “SELECT BUTTON”.A new screen now displays with the options: LEARN, FAV,MACRO and EXIT. Touching the EXIT option will leave themenu without making any changes.3. Touch either the LEARN, MACRO or FAV option. A new screennow displays with the following options:ALL – Erases ALL of the specified LEARNED, MACRO or FAVbuttons everywhere in the remote.DEVICE – Erases all the LEARNED or MACRO buttons in aSINGLE component. This option is not available for FAV(Favorite) channels since they are not tied specifically to acomponent.KEY – Erases one button only.