JBL AV2 User Manual

Also see for Control Series: Assembly instruction guide Owner's guide Owner's manual Owner's guide Owner's manual

Contents

JBL AV2 User Manual Manual pdf 107 page image

JBL ® Performance™ Series AV2 Audio/Video Processor Appendix CC-134. If you touch ALL, the remote will prompt you by displaying“SURE?” After the SURE prompt is touched, all the buttons will beerased.5. If you touch DEVICE, a list of component options are displayed.Touch the component option that you wish to erase. The bottomof the screen will flash “ERASE” twice, then “ERASED”.6. If you touch KEY, you’ll need to navigate to the component thatyou want. Touch a button to erase it. The bottom of the screen willflash “ERASE” twice, then “ERASED”.7. When finished, exit the Setup mode by pressing the Main buttonuntil the touchscreen displays MAIN in the menu heading area.The remote control is in normal operation mode again.RESTORING FACTORY DEFAULT SETTINGSIf you’re afraid you’ve accidently overwritten functions that youwanted, or want a “clean slate” to start from, the remote control canbe reset to its factory default settings. Follow the instructions below torestore the factory default settings.Note: Restoring the Factory Default Settings will ERASE all customizedfeatures, including renamed components, learned buttons andmacros.1. On the remote control, press and hold the Main and Stop buttonsat the same time. The bottom of the touchscreen flashes“WARNING!”NOTE: You now have three seconds to perform the next step. If abutton is not pressed within three seconds, the RESET heading willrevert to MAIN, indicating that the remote control is no longer inReset mode. If this occurs, you will need to repeat this step to re-enterthe Reset mode.2. After about 10 seconds, “RESET” is displayed in the Menu namesection at the top of the LCD touchscreen.A new screen now displays with three options: ALL, PROG andEXIT. Touching the EXIT option will leave the menu withoutmaking any changes.3. Touch the ALL option. The remote will prompt you by displaying“SURE?” After the SURE prompt is touched, the factory defaultsettings are restored.4. When the remote is done restoring the factory default settings, themenu heading reverts to MAIN. When the touchscreen displaysMAIN in the menu heading area, then the remote control is innormal operation mode again.