JBL DCR600 II Owner's Manual

Also see for CINEMA PROPACK 600: Owner's manual Service manual

19DVD600II Front Panel ControlsMain Power Switch: Press this buttonto apply power to the DVD600II. When theswitch is pressed in, the unit is placed in aStandby mode, as indicated by the amberPower Indicator surrounding theSystem Power Control . This buttonMUST be pressed in to operate the unit. Toturn the unit off and prevent the use of theremote control, this switch should be presseduntil it pops out from the front panel so thatthe word “OFF” may be read at the top of theswitch.NOTE: This switch is normally left in the “ON”position.System Power Control: When theMain Power Switch is “ON,” pressthis button to turn on the DVD600II; press itagain to turn the unit off. Note that the PowerIndicator in the center of the switchwill turn green when the unit is on.Power Indicator: This LED will be illu-minated in amber when the unit is in theStandby mode to signal that the unit is readyto be turned on. When the unit is in operation,the indicator will turn green.Disc Tray: Holds up to five DVD or CDdiscs that can be played one at a time in theDVD600II.Disc Skip: Press twice in quick succes-sion to change the disc being played. This willmove the tray forward to the next occupiedposition, skipping over the empty-discpositions.Search Forward/Reverse: Press tomove forward or backward through a disc atone of four speeds. Each press and release willincrease the search speed, as indicated in theon-screen display. Once you have selected thedesired speed, release the button and the discwill continue to search at fast speed. Toresume normal playback speed, press thePlay Button .Open/Close Button: Press to open orclose the Disc Tray . Upon closing thedisc tray, the On Screen Library system willbegin to identify all loaded discs.Skip Forward/Reverse: Press to moveforward or backward through the music tracksor chapters on a disc.Stop: Press once to place the disc in theResume mode, which means that playback willstop, but (as long as the tray is not opened orthe disc changed) DVD playback will continuefrom the same point on the disc when the Playbutton is pressed again. Resume will also workif the unit was turned off. To stop a disc andhave play start from the beginning, press thebutton twice.Play/Pause: Press to begin playback ofa disc, or to momentarily pause playback. If aDVD is playing, action will freeze and a stillpicture will be displayed when the button ispressed.Direct Access Buttons: Press one ofthese buttons to play any of the five discsloaded in the Disc Tray.Information Display: This display con-tains a variety of indicators that provide infor-mation about the status of the DVD600II andthe disc currently playing.Display Dim: Press this button to adjustthe brightness of the Information Display by50% or to turn the display off completely in thefollowing order: FULL BRIGHTNESS ➔ HALFBRIGHTNESS ➔ OFF ➔ FULL BRIGHTNESS.Remote Sensor: The sensor thatreceives the infrared commands from theremote control is behind this area. Do notcover or obscure this part of the front panel, inorder to avoid a malfunction with the remote.96KHz 24bit