Jenn-Air JDRP548WP02 Use & Care Manual

Also see for JDRP430WP01: Installation instructions

Contents

Jenn-Air JDRP548WP02 Use & Care Manual Manual pdf 10 page image

To Clean:IMPORTANT: Before cleaning, make sure all controls are off andthe oven and cooktop are cool. Do not use oven cleaners, bleachor rust removers.1. Remove the burner cap and burner base and clean accordingto "General Cleaning" section.2. Clean the gas opening with a damp cloth.3. Clean clogged burner ports with a straight pin as shown. Donot enlarge or distort the port. Do not use a woodentoothpick. If the burner needs to be adjusted, contact atrained repair specialist.f4= Replace the burner cap, making sure the alignment pins areproperly aligned with the burner cap.20,000 Btu/h Stacked Power BurnerA-; z,..................... ....................B/A. IncorrectB. Correct15,000 Btu/h Burner_ ....__ BA. IncorrectB. Correct5,000 Btu/h Simmer/Melt BurnerA. IncorrectB. CorrectTheandTo1.2.3.4=ABA. Drip trayB. Griddlechrome electric griddle system provides an evenly heatedeasy to clean cooking surface.Remove plastic film and clean with hot, soapy water prior tofirst use.To avoid scratching the griddle, do not place any pots or panson the griddle.To avoid scratching the griddle, use only heat resistant plasticor wooden utensils.The griddle surface is ready to use, and does not need to beseasoned.Pouring cold water on a hot griddle may warp the griddle,resulting in an uneven cooking surface.Use:Position the drip tray under the front edge of the griddle tocatch grease and food residue.Push in and turn the control knob to desired temperature.Refer to the griddle Preheat Chart for preheat times.The griddle light will turn off when the griddle has finishedpreheating. The griddle light will turn on and off during use toindicate that the griddle element is maintaining the selectedsurface temperature.Place food on the griddle and cook to desired doneness.5.L........................../Turn on the burner. If the burner does not light, check capalignment. If the burner still does not light, do not service thesealed burner yourself. Contact a trained repair specialist.10