114Terminal DescriptionValue Number(s) Function1)0 none none No signals are active on terminal X2A.10 toX2A.171 X2A.16 EN Only the enable signal is active on X2A.16. Drivewill not run until one of the direction signals onX2A.14 or X2A.15 are active2 X2A.17 RST Only the fault reset signal is active on X2A.174 X2A.14 U Only the up signal is active on X2A.14. Drive willnot run until enable signal on X2A.16 is active.5 X2A.16,X2A.14 EN,U Both the enable and up signals are active. Thisis normal during operation.8 X2A.15 D Only the down signal is active on X2.4. Drive willnot run until enable signal on X2.1 is active. X2A.16,X2A.15 EN,D The enable and down signals are active. This isnormal during operation.16 X2A.10 I1 Only the option input signal at X2A.10 is active.Drive will not run until enable signal on X2A.16and direction signal on X2A.14 or X2A.15 areactive.17 X2A.10,X2A.16 EN,I1 Both the enable and option input signals areactive. A direction signal is required to allowoperation.21 X2A.10, X2A.14,X2A.16EN,U,I1 Enable, up and option input signals are active.In analog speed mode, the drive should run.25 X2A.10, X2A.15,X2A.16EN,D,I1 Enable, down and option input signals areactive. In analog speed mode, the drive shouldrun.32 X2A.11 L Only the Leveling speed signal at X2A.11 isactive. Drive will not run until enable signal onX2A.16 and direction signal on X2A.14 or X2A.15are active.33 X2A.11,X2A.16 EN,L Both the Enable and Leveling speed signalsare active. A direction signal is required to allowoperation.37 X2A.11, X2A.14,X2A.16EN,U,L Enable, Up and Leveling speed signals areactive. The drive should run in binary speedmode.41 X2A.11, X2A.15,X2A.16EN,D,L Enable, Down and Leveling speed signals areactive. The drive should run in binary speedmode.1) Function is described for Binary speed selection (LF.2 = bnSPd). If using digital speedselection use terminal number and table for LF.2=d SPd on page 73.Diagnostic ParametersTerminal X2AThis parameter displays the status of the digital inputs on terminal X2A.Each input has a specific value. See the table below for decoding.X2A Input state
