375 4 3 2 110 9 8 7 615 14 13 12 11Max. Load Capacity depending on Voltage SupplyMax. load capacity at +7.5 V:300 mA. The specified current is reduced by the load current takenfrom the second encoder interface X3B interface (see section 3.2.6).Pre-manufactured Hiperface cables offer the best solution against noise and disturbance while atthe same time saving installation time. The cables come in standard lengths of 5m,10m,15m,20m,25m, and 30m.Cable Part Number00.S4.80-00xx xx = length in meters, 10 = 10 metersMating Connector00.0.12-003U for encoder (solder type)Running in ConduitWhen this cable must be pulled through metallic conduit, it is necessary to over size theconduit! Use of a 1 1/2 inch trade size conduit will allow the connectors to pass without removal ofthe connectors. Cutting the cable, or removal of the connectors or their housings voids the warrantyand will result in problems with electrical noise after the fact.Drive connectionX3A Female SUBD15 HDCircular connector onHIPERFACE encoder.���� �����������4 REF_SIN red SIN + blue14 DATA - pink15 DATA + gray3 REF_COS yellow8 COS + greenShield wire tied to housingWire color13 0V (com) white10 +7.5V brownShield wire tied to housingwhich is earth ground.Encoder pin-out X3A pin-out channel 1REF_SIN 4SIN + 8DATA - 7DATA + 6REF_COS 5COS + GND 11+7.5V 10Note: Inner pair shields are tied to 0V (com),pin 13, not earth ground!Installation and ConnectionHIPERFACE CablePin No Signal Description1 - -2 - -3 REF_COS signal input A- (difference signal to COS+)4 REF_SIN signal input B- (difference signal to SIN+)5 - -6 - -7 - -8 COS+ signal input A (absolute track for counter and direction detection) SIN+ signal input B (absolute track for counter and direction detection)10 +7.5V Supply voltage for encoder11 - -12 - -13 COM reference potential for supply voltage14 -DATA Data channel RS48515 +DATA Data channel RS485
