KERN EG 220-3NM Operating Instruction

Also see for EG 220-3NM: Service manual Operating instruction

Contents

KERN EG 220-3NM Operating Instruction Manual pdf 19 page image

EW/EG-N/EWB-e-1627 195.5 Connecting peripheral equipmentThe balance must be disconnected from the mains before connecting or disconnect-ing additional equipment (printer, PC) to or from the data interface (see chap. 8.)Only use KERN accessories and peripheral equipment with your balance. Thesehave been ideally coordinated to your balance.5.6 Initial start-upA warm-up time of 10 minutes stabilises the measured values after switching on.The accuracy of the balance depends on the local acceleration of the fall.Please be sure to observe the information in the chapter on adjusting (chap. 5.7).5.6.1 Power displayIf the (*) sign can be seen, the balance is beingsupplied with power via the mains adaptor. Thebalance is in weighing mode when the key isoperated.The power display is then no longer to be seenon the display overview.5.6.2 Bar graph displayweighing dish unloaded half of weighing range weighing range is usedto full capacityThe weighing range of the balance is divided into 20 graphic cuboids. Zero (0) willappear on the graphic display if there is no weighing value on the balance. 10 graph-ic cuboids are displayed if the balance is loaded up to one half of its weighing range.Information:If tare weighing is being carried out, the graphic weight display will continue to indi-cate the number of cuboids of the tare weight.*