Kenwood DMX1037S Instruction Manual

Connection/Installation30Ñ Connecting wires to terminalsILLUMIANT CONTSTEERING WHEELREMOTE INPUTREMOTE CONTPRK SWREVERSEP. CONTCAM+CAM–S SENSFuse (15A)When using the optional power amplifier,connect to its power control terminal.(Max. 200mA, 12V)Depending on what antenna you are using,connect either to the control terminal of themotor antenna, or to the power terminal forthe booster amplifier of the film-type antenna.(Max. 300mA, 12V)Blue/White(Power control wire)Green/WhiteGreen/RedTo CMOS-3xx series (optional accessory) cameracontrol terminalPink (Speed Pulse Input) (2m) Blue(Antenna control wire)To car light control switchOrange/White(Dimmer control wire)Connect to the vehicle’s speed pulse harness.Do not cut the "S SENS" tag or failure may result.Purple/White (Reverse sensor wire) (2 m)Light Blue/Yellow(Steering remote control wire)Connect to vehicle’s reverse lamp harness whenusing the optional rear view camera.To steering remoteTo use the steering wheel remote controlfeature, you need an exclusive remoteadapter (not supplied) matched to your car.If no connections are made, do not letthe cable come out from the tab.Purple/BlackTo rear right speakerTo rear left speakerTo front right speakerTo front left speakerSpeaker impedance: 4-8 ΩPurpleGreen/BlackGreenGray/BlackGrayWhite/BlackWhiteAccessory 1Connect to the vehicle’sparking brake detection switchharness. Light Green(Parking sensor wire)(2 m)For best safety, be sure toconnect the parking sensor.Ignition key switchRed(Ignition wire)Yellow(Battery wire)Car fuse boxBatteryBlack(Ground wire) ¤(To car chassis)