6 | EnglishAbout Bluetooth Hands free controlRefer to the instruction manual of the BluetoothHands Free Box KCA-BT100 (optional accessory).However, the following control methods of thefunction for this unit may be different from theInstruction manual; therefore, refer to the followingsupplemental instruction.1. Press the Control knob. Select the "DIAL" display.2. Press the [FNC] button.3. Select the number to recall by turning the Controlknob.4. Press the Control knob.1. Operation is the same. Refer to the instructionmanual of KCA-BT100.2. Press the [FNC] button.3. Select the number to memory by turning theControl knob.4. Press the Control knob for at least 1 second.1–3. Operation is the same. Refer to the instructionmanual of KCA-BT100.4. Press the Control knob.5. Select "YES" using the Control knob.6. Press the Control knob.7. Press the [FNC] button.About Menu operationFor how to operate Menu, refer to in this instruction manual. For the items to be setup, refer to the instruction of Hands Free Box.About display of Cell-Phone StatusCell-Phone Status is displayed in the status displayof this unit. For the information about the displayedicons, refer to the instruction manual of HandsFree Box. Bluetooth connection status cannot bedisplayed.Handling CDs• Do not touch the recording surface of the CD.• Do not stick tape etc. on the CD, or use a CD withtape stuck on it.• Do not use disc type accessories.• Clean from the center of the disc and moveoutward.• When removing CDs from this unit, pull them outhorizontally.• If the CD center hole or outside rim has burrs,use the CD only after removing the burrs with aballpoint pen etc.CDs that cannot be used• CDs that are not round cannot be used.• CDs with coloring on the recording surface or CDsthat are dirty cannot be used.• This unit can only play the CDs with .This unit may not correctly play discs which do nothave the mark.• You cannot play a CD-R or CD-RW that has not beenfinalized. (For the finalization process refer to yourCD-R/CD-RW writing software, and your CD-R/CD-RW recorder instruction manual.)The marking of products using lasers(Except for some areas)CLASS 1LASER PRODUCTThe label is attached to the chassis/case and saysthat the component uses laser beams that havebeen classified as Class 1. This means that the unit isutilizing laser beams that are of a weaker class. Thereis no danger of hazardous radiation outside the unit.Notes
