Kenwood KDC-X9006U Instruction Manual

Also see for KDC-X9006U: Firmware update guide Service manual

8 | EnglishGeneral featuresVolumeIncreasing VolumeTurn the [VOL] knob clockwise.Decreasing VolumeTurn the [VOL] knob counterclockwise.AttenuatorTurning the volume down quickly.Press the [ATT] button.Each time you press the button, the Attenuatorturns ON and OFF.When the Attenuator is ON, the "ATT" indicatorblinks.LoudnessCompensating for low and high tones during lowvolume. (Only the low tone is compensated forwhen the tuner is selected as a source.)1 Enter Loudness modeUsing the Control knob, select "DSP" > "SNDCONT" > "LOUD".For the operation method, refer to Control mode> (page 9).2 Select the LoudnessTurn the Control knob.Each time you push the knob, the Loudness turnsON and OFF.3 Exit Loudness modePress the Control knob.Audio Control1 Select the source to adjustPress the [SRC] button.Refer to (page 7).2 Enter Audio Control modePress the [VOL] knob.3 Select the Audio item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4 Adjust the Audio itemTurn the [VOL] knob.Adjustment Item Display RangeRear Volume "REAR VOLUME" 0 — 35Subwoofer level "SUBWOOFER LEVEL" –15 — +15Balance "BALANCE" Left 15 — Right 15Fader "FADER" Rear 15 — Front 15Exit Audio Control mode (Volume control mode)5 Exit Audio Control modePress any button.Press a button other than the [VOL] knob, [0] and[ATT] button.Audio SetupSetting the Sound system, such as Volume offsetand Dual Zone.1 Select the source to adjustPress the [SRC] button.Refer to (page 7).2 Enter Audio Setup modePress the [VOL] knob for at least 1 second.3 Select the Audio Setup item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4 Setup the Audio itemTurn the [VOL] knob.Adjustment Item Display RangeVolume offset "VOLUME OFFSET" –8 — ±0 (AUX: -8— +8)Dual Zone System "2 ZONE" ON/OFF⁄• Volume offset: Sets each source’s volume as a differencefrom the basic volume.• Dual Zone SystemMain source and sub source (Auxiliary input) outputFront channel and Rear channel separately.- Set up the channel of sub source by System Setting> (page 33).- Select Main source by [SRC] button.- Adjust the volume of Front channel by [VOL] knob.- Adjust the volume of Rear channel by

(page 8).- The DSP Control will be disabled.• You can use the Dual Zone System only when you haveset the rear speaker to any mode other than "None" inthe (page 10).5 Exit Audio Setup modePress the [VOL] knob for at least 1 second.